Component rejection on an SMT placement machine is a decision, not a single fault. The system may reject a part after pickup, vacuum check, vision recognition or correction when the result falls outside the allowed process window. A practical guide outlines the most frequent root causes and a disciplined troubleshooting sequence.
Feeder indexing errors, cover-tape problems and damaged pockets often prevent correct presentation. Wrong nozzle size, contamination, wear or vacuum leakage produce missed or unstable pickups. Vision failures frequently trace to lighting, low contrast, incorrect package library data or polarity mismatch. Material variation, moisture, static and contamination can change both pickup and recognition even when the machine setup is unchanged.
The guide stresses that widening vision tolerance can reduce alarms while allowing defective placement to continue. The safer method is to confirm the real component condition and library data first, change one variable at a time, and record results by part number, feeder, nozzle and material lot.
The full discussion is available in this overview of SMT machine component rejection. It is written for engineers and production teams who need fewer false rejects and clearer process data.